Aluminum metalized polypropylene film.
Aluminum-Zinc alloy metalized polypropylene film.
Aluminum-Zinc alloy metalized polypropylene film with heavy edge.
Aluminum metalized polyester film.
Aluminum-Zinc alloy metalized polyester film.
Aluminum-Zinc alloy metalized polyester film with heavy edge.
Width: Film Slit Width +/-0.2mm
Inner Diameter: 75mm +1.0mm/ -0.5mm
* Roll Outer Diameter:
For slit widths 4.0mm up: 155 +6/-15mm
For slit widths 10.0mm up: 180 +8/-18mm
For slit widths 25.0mm up: 240 +10/-20mm
Film is wound on solid cores, with the metalized layer inside.
Rolls are wound up to the specific outer diameter.
The loose end of film is held in place by a closing sticker.
Rolls are always packed in pairs.
There is plastic foam between the rolls to protect the electrode
The piled rolls are packed in plastic bag and heat-sealed with
desiccants after vacuum removal.
Labels inside the bags mark film type, thickness, width, free
margin width and resistance.
The bags are packed in carton cases.
The carton cases are packed in wooden cases or reinforced carton.
1. Film should be stored in its original packing until use. The
temperature should be controlled to 5 - 35oC and humidity less than 85%RH.
2. On exposure to moisture, the thin metalized layer is likely to
be easily oxidized. Therefore, after the packing is opened, the
rolls should be used as soon as possible.
3. It is recommended that the opened rolls be stored in temperature
conditions of 15 -25oC and humidity of less than 60%RH.
4. Film kept sealed in the original packing and stored as described
above is guaranteed according to the following conditions:
Al metalized Film: 12 months from the delivered date.
Al/Zn Alloy metalized Film: As Zn is relatively unstable;
preservation period depends on the resistance of the film:
10 Ohms or less 6 months (from delivery date)
10 to15 Ohms 3 months (from delivery date)
15 Ohms 1 month (from delivery date)